View Advertiser Index
|
Posted on 5/18/2012 9:31:25 AM
|
lots 4 sale no junk
Used IMCA hoosiers. $40 each 65% tread left. Freshly ground ready to run.
Used chrome real wheels 5 on 5 3 inch dinged 20, like new 60 each. Have a few left.
Dart 49cc 180cc heads fresh from machine shop, good big springs, manley race flow under cut lw valves. 7/16 pro series studs. $650 complete
4.75 bolt pattern Used Floater hubs complete with brgs, rotors and lug nuts. Used Ace\winters\prc brand. $200 pair
New 5 on 5 winters\prc hubs, complete with brgs, lug nuts, seals etc. NEW. $300 pair
60 inch centered floater housing. This has center less ground tubes for bolt on floating mounts etc�NEW $375
Axles all 31 spline. 28.5 solid, 29.5 gundrilled
Ultrashield full containment seat 16 inch. located in Newton Iowa. $400
RHS cast iron heads, CnC ported by Hvh and assembled by Jim Wyman, some hand port work in chambers around plugs. fereah hollow valves, 2.02/1.6. Isky springs, ten degree locks, retainers, screw in pro series 7/16 studs. $2000 complete dyno time only Due to rules changes.
13 inch 180 lb afco rear spring. $25
5.5x9.5 springs 1100/1200/1300 $10 each
5.5x9.5 New Eibach 780/700/650/680 $40 each
New 15% reduction krc serpentine lower pulley. $20 shipped.
Used serpentine krc pulleys 3.5 lower and uppers. 1-1 $10 each
Used Krc lower pulley and piece that mounts to the balancer. Serpentine. 3.5 not r lock. $20 both
Crower ultra light 41# gun drilled mains and rods and seriously profiled throws! 434 crankshaft. Used. .010 400 mains, 2� st rods. Big block snout. Also have low nights Ati Balancer for this. Both $1400
Mahle flat top 434 pistons. 4.165 bore 1.00 pin height for 434,406 or 377 depending on rod length. NEW pistons with -5cc valve reliefs. New pins and locks included. $425
Cleaned and checked double hump head cores, bare. $50 each
Steering wheel quick release and part you weld to shaft. $10
Contact Information:
Jeff, Mc Clelland,Ia
Phone: (712)310-1183
Email: [email protected]
|
|
|
|
