View Advertiser Index
|
Posted on 5/25/2015 9:37:40 AM
|
fresh 350 race or street rod motor
ok, i have a fresh engine for sale.... needs assembled... heads are world heads with 2.02/1.60, port matched, and milled .005. stainless steel valves, retainers, springs. intake seat is .045 wide, exhaust is .060 wide. the setup height is 1.800. 010 block. 4 bolt bolt main bored .040 over. finish honed with deck plate to 4.0415 inches. the main journals are line honed with main studs installed. the block was very square to start with and is square decked at .012 per side. cam bearings installed. cam shaft was run through so to check fitment. crank is a stnd and polished. we have .001 bearings for it. ARP bolts all around, rods are resized to the middle of spec. range. i have all the other parts sitting here in my living room. will take pictures and send if needed. i have comp cam push rods, power forged sealed power pistons. guide plates if you want them. new timing kit, double roller chain. roller rockers with 1.5 rocker arms. with a wide slot so you can adjust how you want. again, its all in boxes. you have to assemble. hard work is done, just put it together. any questions just call me on my number here, or if you want, you can call don remington at remington automotive. he will fill you in on anything i missed. he has built some very nice 305 sprint car motors and speedway motors can vouch that. i have almost 3500 in this motor between parts and machine work and labor. im asking 2100 obo. i have invoices and a cover page going over what he did for the machine work. if you would like to call him for more information, it is don remington at remington automotive. 308-895-2240. best times are between 6-9pm. i have all the parts here at my house and my number is 308-375-4231.
Contact Information:
anthony heiser
Phone: (308)375-4231
Email: [email protected]
|
|
|
|
