View Advertiser Index
|
Posted on 11/9/2007
|
Parts For Sale
Wesico pistons, 400+.030 uses 6" rods $350
SOLD 360ci, 350 4 bolt block bored to .056 needs honed yet, line bored and square decked,oil passages drilled and tapped, water passages cleaned and debured, all the bolt holes have been cleaned and chased through, $400 SOLD
400 block, prebored to 4.180, square decked and line bored with main studs. Has bottom 1" hard blocked. oil passages drilled, coolant passages opened up. With all the machine work done to this block it normally sells for $700. But it has some slight shadows that didnt clean in the cylinders. So I will sell it for $300
SOLD 360ci 9-1 motor,350 4 bolt block +060, flat top speed pro pistons, fresh reconditioned gm rods with good bolts,fresh gm cast crank that is still std on mains and rods,clevite bearings, speed pro rings, $700 short block or with heads for $1200 SOLD
360ci 9-1 motor, 350 4 bolt block, speed pro H-113CP pistons, Scat 4340 I beam rods, gm crank 10/10, balanced, clevite bearings and speed pro moly rings, all I need to do is finish assembling it, $1100, or as a complete motor with heads for $1600
New weight plates for external 383 and 406 balancing, $6
New Guide Plates, $10 a set while supplies last
SOLD 991 heads, 2.02 int/1.6 exh. , new guides,pinned studs, new springs and locks, $375 SOLD
462 double humps, 2.02 int, 1.6 exh. screw in studs and guide plates, ready to bolt on, $350
Flex plates 350 and 400 $5 each
New Flex plates $45
2 brl intakes, cleaned and crack checked, checked for straightness, $50
Contact Information:
Terry Cohoon
Phone: (712)283-2283
Email: [email protected]
|
|
|
|
