View Advertiser Index
|
Posted on 11/9/2007
|
Parts For Sale
Wiseco pistons, 350 + 030, uses 6" rods and a 3.625 stroke makes a 370ci motor. $250
7 Diamond forged flat tops 350+040 use with 6" rods $100
Eagle 4340 crank, 3500 stroke, $300
350 block, 4 bolt, bored +060 not honed yet, line bored, square decked, oil passages drilled and tapped, coolant passages slagen removed, $400
Std bore 400 block $150
487 casting heads, cleaned and checked, surfaced, new guides. 2.02 int, 1.6 exh, new springs, retainers and locks, bronz guides, pinned studs,$550
882 castings, surfaced, cut for 2.05 int and 1.6 exh. cut for screw in studs and guide plates,bronz guides, mild port work $275
I have 1 292 angle plug head, nice port work $200
1(new) Edelbrock RPM alumanium head, Part #6061 bare $400
set of 291 casting heads, complete stock ready to bolt on ,been setting on the shelf, $250
New Guide Plates, $10 a set
New 7/16 screw in studs, $15 set
New ARP cam lock bolts, $5 pkg
New JE wrist pins, part #927-2.750-15-51S, 130 grams, $100
New Diamond wrist pins, 927-2.850 tappered ends, 140 grams $75
2 and 4 brl intakes, cleaned and crack checked, checked for straightness, $50
Pete Jackson gear drive $50
583 gears used good shape 28 or 31 spline $225
Sunnen rod hone $400
Misc stuff
Carrier shop furnace, used only 6 months, set up on propane has air conditioning coils, $200 like new
Redi heater uses kerosene $50 like new
turbo 400 trans, good shape $100
4.3 litre V-6 rebuilt engine, long block, less than 500 miles on rebuild, got hit in the back. hydraulic roller cam, asking $700 or best offer.
4.3 litre V-6, rebuilt short block, non roller cam, $500 or if you assemble it $300
Contact Information:
Terry Cohoon
Phone: (712)283-2283
Email: [email protected]
|
|
|
|
