View Advertiser Index
|
Posted on 11/9/2007
|
Parts/Mod Roller For Sale
Mod chassis for sale, basic roller, good straight car for beginner or b-mod. Never been stubbed, All the parts I have go with it. This is a tall caged car. I have had alot of calls on this. It will take some work to finish it, and a new body if you want to put one on. But you wont find a used car any straighter than this one.there are a lot of chassis out there that have been wrecked and stubbed, your just buying thier problems.$1,500 or any reasonable offer close to it.
401 ci sbc motor. Std bore+, JE forged domed pistons, eagle 6" rods, Scat lightenen crank, moly file fit rings, clevite bearings, internaly balanced, small 6" balancer, 186 casting heads, screw in studs, ECT,ECT. this motor has 6 night on it, $2200 for the long block or $1800 for the short block,
350 chevy motor, just pulled out of a pickup.Runs good, performer intake, quadrajet carb,starter, this is complete. $350
Newer style 350, 89 and up motor. 60,000 miles on it. has trottle body intake on it. just pulled out. $350
4.3 V-6, long block, 500 miles on rebuild, hydraulic roller cam, $ 500
350 4 bolt block, +060, bored but not yet honed, Line bored,clearenced for stroker crank, all the holes have had tread cleaner run through them.good straight deck surface,all the casting slag has been removed for lifter area, Nice block $300
400 block, 2 bolt block fresh +040 bore, not yet honed, straight line bore, oil passages drilled and tapped $300
4412 Holley carb,Has 6 hrs total time on it, stock has not been modified in any way. $200 firm.
1 set of 291 casting heads, bone stock, they are rebuilt ready to bolt on $150
882 casting heads, cleaned and crack checked, new guides $100 pr.
Still have head cores for sale.???????????? call for your needs.
Edelbrock Performer intake, good shape, $50
2 barrell intake cores,$10
Engine seal kits, seals up that motor for storage or transportation, $25
383 balance plates $9 shipped
Guide plates flat type, $8 set
NEW Comp Cams and Crane Cams hardened black oxide retainers these are stock diameter, $20 a set while supplies last.
New pr. of copper head gaskets, .060 thick $50
Pull bar brackets, pan hard bar brakets, disc brake brackets, shock tabs, gussets, J bar brackets, all kinds of tabs and other brackets for sale
I have lots of good new and used parts on hand, call if you need something special.
Contact Information:
Terry Cohoon
Phone: (712)479-2251
Email: [email protected]
|
|
|
|
