View Advertiser Index
|
Posted on 11/9/2007
|
400 Small Block
Block has been hot tanked, bored .030 over, decked and new cam bearings and frost plugs installed.
3951511 400 70-80 255-265 car & Truck 2 & 4-Bolt 3-freeze plugs
Heads porting and polishing done by Charlie�s Speed in Blair, They were on another engine and have about 3-500 miles on them. They are the 2.02/1.60 valves.
3991492 327/350 68-73 2.02/1.60 64cc Angle plug
Crank .010 under. Balanced.
3951529 400 70-80 2.65/2.10 3.75 Nodular Iron
The pistons are a flat top speed pro with anti-friction skirt coating with the heads and the rods it will have a 9.8:1 compression ratio. Flat top piston with 12.5cc cup and pressed pin.
The crank and piston/rods have been balanced.
I have Sealed Power Chromemoly Piston Ring Sets. Also, main bearing set, rod bearing set, high volume oil pump and the gasket set which are all federal mogul.
New flex plate and fluid harmonic balancer both are SFI approved/rated.
If necessary I have shorty headers, nice valve covers and a single plane intake manifold.
The only thing really missing is the cam, lifters and pushrods.
I have over $3000.00 invested in parts and work and would like to get $2000.00 or somewhere close to that out of it.
Cell 402-290-9168
Contact Information:
Hugh Schuett
Phone: 402-490-3952
Email: [email protected]
|
|
|
|
